|
Shaft Seal
|
If the pump is leaking from the mechanical seal, the seal should be replaced immediately. More
information.
|
|
Simple Replumb
|
If the pump is leaking at the intake or discharge plumbing, we replumb it with a CPVC machined nipple and PVC.
More information.
|
|
Replace All Seals
|
An older pump can often be restored to "like-new" performance with a completely new set of seals and
gaskets. More information.
|
|
New Motor
|
If the motor will not operate, we follow a thorough troubleshooting regimen to carefully diagnose the problem.
More information.
|
|
Capacitor
|
Often a non-functioning motor is simply due to a bad capacitor. As a part of our troubleshooting
routine, we check the capacitor. More information.
|
|
New Pump
|
If the entire pump needs to be replaced, we sell you a new one, install it and provide warranty service if
needed in the future. More information.
|
|
Not sure what the problem is?
|
We offer expert
low-cost troubleshooting on all pool equipment.
In most cases, the charge is just $45.00 and you can rest assured, knowing it is being handled by an expert.
|
|
To request a service call, please email us with the nature of the
problem. We will set up a time to come out and look at the problem. You will be asked to authorize
the initial service call through our secure ordering process. We will come out and look at the problem and get your approval on any needed repairs.
|
